How to Fix a Leaky Toilet For Dummies

 

You might be facing some issues in your toilet, sometimes clogs, sometimes leaking and a lot of more problems. If you are fed up of these issues, then you should replace your toilet. Here’s an ultimate guide for finding best toilets for home. Do checkout and if you don’t want to replace, then here’s step by step guide to how to fix leaking toilet.

Step 1

If you see a small water on the floor around the bottom of your toilet bowl it may have a damage wax gasket seal to restore the seal you have to eliminate the toilet bowl from the ground this is a job that requires much more work than it does money, in fact, all you’ll need to buy is a replacement wax seal and a small tub of plumbers putty the first the step is to shut off the water much older toilets and most newer ones have a shutoff valve turn this valve clockwise.

Step 2

If your toilet doesn’t have a shutoff valve beneath the tank you have to turn off the water at the main valve the second step is to flush the toilet to empty the tank and then remove as much of the water as possible first use a small cup and then SAAP up the rest with a sponge don’t worry tank water is relatively clean but you’ll want to wash your hands after you’re done for.

Step 3

Place a pan under the shutoff valve to catch any dripping water and then use a wrench to disconnect the riser.this brings the fresh water to the tank don’t just loosen the nut remove the tube completely so that it doesn’t get bent or damaged.

Step 4

Loosen and remove the bolts in the bottom of the tank that attached the toilet bowl the reservoir tank.

Step 5

Is to lift the tank off the bowl if the tank is wall-mounted you don’t have to take the tank off the wall simply remove the wide pipe leading from the tank to the bowl on each side of the base of the toilet bowl are the nuts that are usually hidden by decorative caps that hold the bowl to the floor.

Step 6

Is to pull the caps off and unscrew the nuts even with the nuts separated the putty along the base of the bowl and the leaking wax ring yet form a strong bond you may need help for.

Step 7

Lightly rock or tilt the bowl back and forth until the seals loosened enough that you can remove the bowl don’t hit the bowl or try to pry it off the floor with a large screwdriver because you may chip or crack the bowl.

Step 8

Is to thoroughly clean off all putty and wax from the bowl the waste pipe and the floor be sure that the floor is clean and dry as well for.

Step 9

Insert the new wax ring over the waste pipe and apply a new 1-inch wide band of putty under the outer perimeter of the bowl rim.

Step 10

Lift the bowl position it over the opening and gently lower it down apply the pressure in a rocking or circular motion to push the ball down fully the bowl must squeeze the wax ring and putty for good adhesion keep pushing the bowl down until it rests firmly on the floor now reattach the nuts to the floor bolts and replace the decorative caps for.

Step 11

Reattach the reservoir tank or connection pipe and attach the water supply line to the tank or shutoff valve finally turn on the water supply remove any excess putty and you’re all set to go so to speak you .

Leave a Reply

Your email address will not be published. Required fields are marked *